RF/MICROWAVE TEST TECHNICIANS FOR PRODUCTION AND RESEARCH & DEVELOPMENT(R & D) PROJECTS.

SALARY: Varies with skills / education / experience

Planar Monolithics Industries Inc (PMI)  currently has openings for  RF/Microwave Test Technicians with 2-5 years experience in touble shooting, tuning, aligning and testing RF/Microwave and Millimeter wave MIC/MMIC Components, Subsystems, Integrated Assemblies that incorporate both active and passive RF components, including  Low Noise Amplifiers(LNA"s), Switches, Switching Matrices Filters, Programmable Attenuators, Oscillators, Phase Shifters, Diode Detectors,  Threshold Detectors, DLVAS, SDLVAS, Frequency Discriminators etc,etc as well as Up and Down Frequency Converters/Receiver Front Ends

We are looking for someone with proficiency in both Analog Transistor, Op-Amps and Digital Control Circuitry for use in Components & Integrated Microwave Assemblies, and who can use RF/Microwave Test Equipment such as Scalar and Vector Network Analyzers, Signal Generators, Spectrum Analyzers, Noise Figure and Power Meters to test and make measurements of such parameters as small signal gain, insertions loss, rejection bandwidths, VSWR, noise figure, isolation, 1 dB compression point, NxM spurious products, phase noise, S-Parameters, and group delay measurements.

Candidates with good hand skills, Microscope skills, and ability to Troubleshoot chip and wire RF/Microwave components & integrated assemblies in a clean room environment is essential. Must also be able to work independently, have good communication skills and demonstrated ability to meet deadlines and report status to customers and the management.

PMI is an equal opportunity employer and considers all qualified applicants for employment without regard to age, race, color, religion, sex, national origin, sexual orientation, disability, or veteran status.

Please send your resume to kmason@pmi-rf.com